Drills & Drivers
Drill/Drivers are designed for drilling holes and for driving screws, bolts and other fasteners.
If you're ready to take on a DIY project, the Drill/Driver will be your most important tool. Becoming familiar with your Drill/Driver will give you a good foundation for the majority of your DIY project list. Browse this section, learn all you can, and make sure to check out the introductional video with Ana White.
Use a low clutch setting on drywall and other soft materials
Using a low torque setting for softer materials helps protect the material from damage by the fastener.
Use a higher torque setting on dense, harder materials
Starting with a low clutch setting, work your way up to a higher setting until you have driven your screw to the depth you want. Leave the clutch set at this setting for subsequent screws, and you'll drive all the screws to the same depth.
Apply a small amount of pressure during drilling and driving to help the drill bit or fastener get a better grip on the material
If drilling a large hole, you may need to adjust the gear setting to position 1 (highest torque)
The piece of metal that goes into the drill's tip. There are bits for drilling holes and bits for driving screws.
The water tube on the top and back of the drill that shows you when you are level with your drilling surface.
The cylinder that opens and closes the jaw of the drill.
The portion at the very tip of the drill that holds the bit in place.
An additional tool required to loosen and tighten the chuck.
The ring around the front of the drill (usually right behind the chuck) that lets you adjust the torque setting.
When the material you're driving into is too dense or tough for the clutch setting, the drill will stop moving the fastener. This is designed to protect your surface from damage. Adjust the clutch to a higher setting to complete the drive.
The switch on top that lets you choose between highest speed, and highest torque.
The kind of chuck that you can loosen and tighten by hand.
The most efficient kind of battery for a cordless drill. They typically charge faster, run longer, and don't slowly fade in power.
Ni-Cad (Nickel Cadmium) Battery
The "old school" kind of battery. They tend to take longer to charge, and they gradually lose power as they run down.
A drill's word for power. High torque means the drill/driver is turning the bit very hard.
Are drills dangerous?If used correctly, and if you follow all the safety requirements in your manual, you can use a drill safely.
How do I know what settings to use?If you're drilling, use high speed and adjust your Drill/Driver to "drill". If you're driving, use low speed, adjust the clutch dial to a high setting, and adjust as needed.
How do I know what type of drill I need?The most common type of drill for DIY is a Drill/Driver. The Drill/Driver is able to handle most around-the-house applications and basic repair work.
What's the difference between a Drill/Driver and an impact driver?While both a drill/driver and an impact driver drill holes and driver fasteners, an impact driver is optimized for high-torque, efficient fastening.
How do I switch between drilling and driving on my drill?Drilling requires drill bits to make holes. Driving requires driving bits to hold the fastener while the drill/driver sinks the fastener into the material. Simply select the appropriate bit. For driving, move the gear switch to the high torque setting, and for drilling move the gear switch to the high speed setting.